4 bridge commands – Asus GigaX User Manual

Page 88

[RIP-disabled interfaces]

You can specify an L3 interface as RIP-disabled interface if you do not want
this interface to deal with any RIP message, either incoming or outgoing.

CLI command : l3 rip interface remove

5.3.4 Bridge

Commands

[Spanning Tree is] [STP Enabled/ RSTP Enabled/ Disabled]

Allows user to specify whether the switch participates in the Spanning Tree
Protocol (STP/ RSTP).

CLI command : l2 stp start

CLI command : l2 stp stop

[Hello Time]
[Forward Delay]
[Max Age]
[Bridge Priority]

Displays the current STP/RSTP bridge parameters setting.

CLI command : l2 stp bridge set

Hello Time (1..10 seconds):[old Hello Time]

Max Age (6..40 seconds):[ old Max Age]

Forward Delay (4..30 seconds):[ old Forward Delay] Delay>

Bridge Priority (0..61440):[ old Bridge Priority]

[Priority]
[Path Cost]
[Edge Port]
[Point-to-point]

Displays the current STP/RSTP ports parameters setting.

CLI command : l2 stp port set

Port Settings (all,…):[all]