Samsung SCH-I800BKAVZW - Manual (Page 82)

76
Scanning and Connecting to a Wi-Fi Network
When you turn on Wi-Fi, your device searches for available Wi-Fi
connections, then displays them on screen.
1. From any screen, sweep your finger downward from the
top to display the Notification Panel.
2. Touch Wi-Fi to turn Wi-Fi On. Your device automatically
scans for available Wiress Access Points.
3. When the scan is complete, touch a Wi-Fi network to
connect. If the Wi-Fi network is open, your device will
automatically connect. If the Wi-Fi network is secured,
enter the password at the prompt to connect.
Note: After connecting to a Wi-Fi network once, your device will save its
settings and connect automatically when you turn on Wi-Fi within the
network’s range.
Adding a Wi-Fi Network Manually
1. From a Home screen, press the Menu Key ➔ Settings
➔ Wireless and network ➔ Wi-Fi settings.
2. Touch Wi-Fi to turn Wi-Fi On.
3. Touch Add Network, then enter information about the
network:
• Network Name (SSID): Enter the name of the Wi-Fi Wireless
Access Point.
• Security: Select the type of security used by the WAP.
• Password: If the WAP is secured, enter the password or hex key.
Note: Depending on the Security protocol used by the WAP, additional
network information may be required.
4. Touch Save to save the settings.