Campbell Scientific TurfWeather Weather Station User Manual
Instruction manual, Turfweather weather station
Table of contents
Document Outline
- Revision and Copyright Information
- Limited Warranty
- Assistance
- Precautions
- Table of Contents
- 1. Introduction
- 2. Cautionary Statements
- 3. Initial Inspection
- 4. Quickstart Guide
- 5. Installation
- 5.1 Power Sources
- 5.2 Site Selection
- 5.3 Communications Considerations
- 5.4 Installation Procedures
- 5.4.1 Assemble the 16776 Tripod
- 5.4.2 Ground Installations
- 5.4.3 16772 Guy-Wire Kit Installation
- 5.4.4 Mounting the TurfWeather Station on a Tripod or Pole
- 5.4.5 SP5 Solar Panel Installation
- 5.4.6 16775 Ground Kit Installation
- 5.4.7 Base Radio and Standard Antenna Installation
- 5.4.8 High Gain Base Station Antenna Installation
- 5.4.9 17342 Short-Haul Modem Installation
- 5.4.10 Auxiliary Battery Unit Installation Procedure
- 6. Maintenance
- 6.1 Solar Panel pn SP5
- 6.2 Battery Pack pn 14159
- 6.3 Temperature/Relative Humidity Sensor pn 14144
- 6.4 Solar Radiation Sensor pn 14009
- 6.5 Rain Gage pn 25585
- 6.6 Wind Speed Sensor pn 14010
- 6.7 Wind Direction Sensor pn 14011
- 6.8 Memory Battery pn 15598
- 6.9 Equipment Removal and Replacement
- 6.9.1 Removing the TurfWeather Station from the Mast or Pole
- 6.9.2 Battery Pack Replacement Procedure
- 6.9.3 Temperature/Relative Humidity Sensor Assembly Replacement Procedure
- 6.9.4 Solar Radiation Sensor Replacement Procedure
- 6.9.5 Rain Gage Replacement Procedure
- 6.9.6 Wind Speed Sensor (Anemometer) Replacement Procedure
- 6.9.7 Wind Direction Sensor Replacement Procedure
- 6.9.8 Memory Battery Replacement Procedure
- 6.9.9 Main Electronics Board (Motherboard) Replacement Procedure
- 6.9.10 Spread Spectrum Radio (all frequencies) Replacement Procedure
- Appendix A. TurfWeather Equipment
- Campbell Scientific Companies