Campbell Scientific TurfWeather Weather Station - Manual (Page 11)

TurfWeather Weather Station
1. Introduction
Campbell Scientific’s TurfWeather® is an automated weather station designed
for OEMs in the turf grass market. It consists of meteorological sensors, a
solar panel or AC to DC charging source, and a protective case that houses the
datalogger/transmitter and rechargeable battery. The case and solar panel
mount to a pole with an outer diameter of 2.5 cm to 4.8 cm (1 in to 1.9 in).
2. Cautionary Statements
• READ AND UNDERSTAND the Precautions section at the front of this
manual.
• Use the lift straps to remove the weather station from the box, since
removing the station by lifting on the sensors may damage the sensors (see
FIGURE 4-1).
• When unpacking and installing the station, avoid resting the weather
station on the wind speed and wind direction sensors.
• WARNING: Under no circumstances should installation be accomplished
during inclement weather to avoid personal hazard due to lightning.
• CAUTION: Connecting an incompatible power source to your weather
station voids your Warranty. It is advisable for you to check with your
local distributor before connecting a power source not purchased with this
weather station.
• The weather station uses a lead-acid battery that must be properly disposed
of. Do not dispose of this battery pack in a municipal landfill, or by
burning it. If you do not know where to dispose of a battery pack, then
contact your local solid waste disposal site for instructions.
• CAUTION: To minimize the possibility of equipment damage or personal
hazard, we strongly recommend a qualified electrician design and install
the grounding system and data isolation components. Improperly
grounded systems can damage host computers and equipment connected to
antennas.
3. Initial Inspection
• Remove the top foam packing from the TurfWeather weather station box
and verify you have all ordered equipment. Report missing or damaged
equipment before installing system.
1