Campbell Scientific TurfWeather Weather Station - Manual (Page 42)

TurfWeather Weather Station
FIGURE 5-19. Yellow wire connected to Battery+ terminal
c. Use new cable ties to secure the cable as it was before you clipped the
original cable tie(s), or reuse the original ties if possible.
d. Place the two sections of the weather station main body together,
making sure that none of the wiring bundles will be crushed by the
edges, or by the seven housing screws when the sections are secured.
e. Reinstall and tighten the seven screws that hold the weather station
main body sections together.
f. Reinstall the TurfWeather station on the mast or pole in original
location and orientation. Reconnect the SOLAR/CHARGER cable.
3. Enclosure Installation:
a. Place the enclosure underneath or opposite of the solar panel to
prevent shadowing on the solar panel (FIGURE 5-20).
b. Attach the enclosure to TurfWeather weather station mounting pole
using the U-bolt, flat washers, locking washers, and brass nuts
supplied. Use the 1/2-inch wrench to tighten the two U-bolt nuts.
c. Attach the 2 pin connector on the 18971 cable to the bottom of the
enclosure (FIGURE 5-21).
d. Attach the 6 pin connector on the 18971 cable to the bottom of the
TurfWeather weather station’s AUXILIARY connector (FIGURE
5-22).
32