Campbell Scientific TurfWeather Weather Station - Manual (Page 48)

TurfWeather Weather Station
has and then release the wires by either cutting the cable ties with the
small wire cutter, or by releasing the cable restraints.
Do not cut the wires to remove the battery pack.
FIGURE 6-2. Main electronic board
h. Disconnect the white battery pack cable connector from the main
electronics board.
Maintain ESD isolation by not touching any electronics boards or
components on the boards inside the weather station.
i. Use the Phillips screwdriver to remove the two screws holding the
battery pack bracket into the electronics section, and remove the
bracket.
j. Lift the battery pack from the weather station and properly dispose of
the battery.
2. Battery Pack Replacement:
a. Insert the new battery pack into the weather station where the
previous battery pack was located.
b. Replace the battery pack retainer and tighten the Phillips head screws
that hold it into the electronics section. Take care not to crimp the
cable from the battery pack under the battery pack, or the retainer.
c. Carefully connect the white cable connector to the main electronics
board, taking care not to touch the board or any components on
electronics boards inside the weather station.
NOTE
NOTE
Battery Cable
White
Connector
Cable Tie
38