Campbell Scientific Solar1000 Station - Manual (Page 19)

CM106 Tripod
Remove the washers, nuts and U-bolt from the U-bolt bracket. Install the
bracket as shown in Figure
1.5-12 (top). Tighten the nuts on the U-bolt until the
lock washers are compressed.
Route the 14 AWG wire from the grounding lug on the bottom side of the
enclosure to the grounding lug on the base of the tripod (Figure
1.5-8). Strip 1/2”
of insulation from each end of the wire. Insert wire ends into the grounding
lugs and tighten.
U-Bolt Bracket
Screw Head
Enclosure Tab
FIGURE 1.5-12. Enclosure with the –LM Bracket
15