Campbell Scientific Solar1000 Station - Manual (Page 15)

CM106 Tripod
1.5.5 Tripod Grounding
Place the clamp over the ground rod and drive the rod (close to the center of
the tripod) using a sledge hammer or fence post driver. Strip 1/2” inch of
insulation from both ends of the black 4 AWG ground wire. Insert one end of
the ground wire between the clamp and ground rod and tighten the bolt on the
clamp. Attach the other end of the ground wire to the lug on the tripod base as
shown in Figure
1.5-8.
Ground Lug
Ground Wire
Enclosure Ground Wire
Enclosure Ground Lug
FIGURE 1.5-8. Ground Rod and Clamp
11