Campbell Scientific ENC10/12, ENC12/14, ENC14/16, ENC16/18 Enclosures - Manual (Page 6)

Enclosures Table of Contents
ii
C. 28960 Stack Mounting Kit.......................................C-1
C.1 Introduction ......................................................................................... C-1
C.2 Mounting Procedure ............................................................................ C-4
D. Keeping Insects Out Of the Enclosure..................D-1
Figures
2-1. Components of the Enclosure Supply Kit ........................................... 3
3-1. Securing components to the enclosure backplate ................................ 4
3-2. Securing cables to the cable tie tabs .................................................... 6
3-3. An ENC12/14 with one 1.5" conduit houses a CR1000 datalogger
and BP24 power supply. Door not shown....................................... 7
3-4. Cable inserted into compression fitting ............................................... 8
3-5. This ENC16/18 enclosure with the “-ES” option houses the
equipment commonly used in a GOES satellite system................... 9
4-1. An enclosure with the “-MM” mounting option attaches to a
tripod mast via u-bolts .................................................................. 10
4-2. This exploded view shows the components of a “-MM” bracket...... 10
4-3. An enclosure attached to a tripod mast.............................................. 11
4-4. Enclosure brackets configured for a tower mount ............................. 12
4-5. This exploded view shows the components of a “-TM” bracket
option ............................................................................................. 13
4-6. An enclosure attached to two tower legs ........................................... 13
4-7. The 19124 bracket attached to a CM110 tripod ................................ 15
4-8. An ENC14/16 enclosure with a “-LM” Bracket................................ 15
4-9. The u-bolt bracket ............................................................................. 16
4-10. An enclosure attached to the leg base of a CM110 tripod ................. 16
4-11. Mounting two enclosures on a single tripod leg ................................ 17
4-12. Attaching the pole mount bracket...................................................... 18
4-13. Inserting the metal band .................................................................... 18
4-14. Securing the enclosure to a pole ........................................................ 19
B-1. 15908 DIN-Rail Stopper installation............................................... B-1
B-2. 15920 Terminal Strip installation .................................................... B-2
B-3. 15907 End Plate installation............................................................ B-2
B-4. 15909 Jumper installation................................................................ B-3
B-5. DIN-Rail bracket mounted onto an enclosure backplate ................. B-3
B-6. An installed and wired 25458 DIN-Rail Terminal Kit .................... B-4
B-7. The 25458 DIN-Rail Terminal Kit facilitates wiring of multiple
sensors.......................................................................................... B-4
C-1. Exploded view of a CR1000 and AM16/32B mounted on a
28960 Stack Mounting Kit........................................................... C-1
C-2. Assembled view of CR1000 and AM16/32B mounted on a
28960 Stack Mounting Kit........................................................... C-2
C-3. Contents of 28960 Stacking Kit....................................................... C-3
C-4. CR1000 mounted to Stack Mounting Kit legs................................. C-3