beautypg.com

Attachment to an instrument mount, 1 tripod mast, Tripod mast – Campbell Scientific ENC10/12, ENC12/14, ENC14/16, ENC16/18 Enclosures User Manual

Page 15: Equipment commonly used in a goes satellite system

background image

ENC10/12, ENC10/12R, ENC12/14, ENC14/16, ENC16/18, PWENC12/14, PWENC14/16, and PWENC16/18

FIGURE 3-5. This ENC16/18 enclosure with the “-ES” option houses

the equipment commonly used in a GOES satellite system

Com
Fittin

pression

gs

4” Cable Tie
Secures Cable
to CR1000

4. Attachment to an Instrument Mount

4.1 Tripod Mast

The “-MM” mount option is intended for mounting our enclosures to the mast
of any of our tripods. An enclosure ordered with this option will be shipped
with a three-piece bracket mounted to the top of the enclosure and an identical
three-piece bracket mounted to the bottom of the enclosure (see FIGURE 4-1
FIGURE 4-2, a
nd FIGURE 4-3).

Attach the enclosure to the mast as follows:

1. Position the enclosure on the north side of the mast.

2. Place the enclosure at the desired height. Please note that the

recommended lead lengths for our sensors assume the bottom of the
enclosure is mounted 3 ft from the ground.

3. Use the furnished 2" u-bolts to secure the enclosure to the tripod mast.

4. Route the 14 AWG wire from the brass tripod grounding clamp to the

enclosure grounding lug. Strip one inch of insulation from each end of the
wire and insert the end of the wire into the grounding lugs and tighten.

9