Kenwood K-731-B - Manual (Page 72)

72 R-K731
Troubleshooting
Symptoms Solution Ref. page
CD
A CD does not play back
when loaded.
z Load the disc correctly with the label side facing upwards.
z Clean the disc. (See .)
z Allow any condensation to evaporate. (See
against condensation>.)
26
74
74
No sound output z Press the [CDE] key.
z Clean the disc. (See .)
26
74
Playback skips. z Clean the disc. (See .) 74
Some audio fi les can't
play back. z The system will not play audio fi les that are corrupted.
z Make sure the audio fi le is supported for playback on the
system.
23, 24
Delay until playback
starts. z There may be a delay prior to playback if there are large
numbers of folders.
28
TAG information is not
displayed correctly. z Refer to to check which TAG
information can be displayed on this system.
23, 24
Symptoms Solution Ref. page
Components connected to the D.AUDIO terminal
The main unit and remote
control cannot control a
Kenwood digital audio player. z Connect the player using the dedicated cable PNC-150.
z Check whether the connected model is compatible.
13
48
Symptoms Solution Ref. page
Remote control
The remote control does
not work. z Load new batteries.
z Use the remote control within its eff ective range.
17
17
Symptoms Solution Ref. page
USB
No sound output when a
USB flash memory or USB
audio player is connected. z Plug in the USB fl ash memory correctly.
z Connect the USB cable correctly.
z Check to make sure the USB audio player is turned on.
12
34
The iPod/iPhone does
not provide sound. z The iPod/iPhone is not properly connected. Remove the
iPod/iPhone from the system, and then connect it again.
32
The iPod/iPhone cannot
be charged. z The iPod/iPhone is not properly connected. Remove the
iPod/iPhone from the system, and then connect it again.
32
R-K731_E.indb 72 R-K731_E.indb 72 2011/10/07 14:08:52 2011/10/07 14:08:52