Equalizer control, Sound effect, Equalizer control sound effect – Kenwood DNX9210BT User Manual
Page 44: P.86), P.87)
86
86
87
Equalizer Control
You can adjust equalizer by selecting the
optimized setting for each category.
1
Touch [Equalizer].
Equalizer screen appears.
Controlling EQ curves
1
Select EQ curve from [Natural],
[Rock], [Pops], [Easy], [Top40], [Jazz],
[Powerful], [iPod], and [User].
NOTE
• [iPod] is available only during iPod source.
Controlling equalizer manually
This setting cannot be performed when you
select [iPod] in the Equalizer screen.
1
Touch [EQ] in the Equalizer screen.
2
Touch the screen and set the Graphic
Equalizer as desired.
Gain level (light green boxed area)
Adjust the gain level by touching the each
frequency bar.
Touching [
2], [3], [5] and [∞] can also
adjust the level. Use [
2] and [3] to select a
frequency, and [
5] and [∞] to set the level.
EQ INIT
Returns to the previous level which the gain
level is adjusted.
Flat
Tone curve becomes flat.
Bass EXT (Bass Extend Settings)
When turned on, the frequency lower than
62.5 Hz is set to the same gain level as 62.5 Hz.
Loudness
Sets the amounts of boost of low and high
tones. “OFF”, “Low”, “High”
SW Level
Adjusts the subwoofer volume. This setting is
not available when subwoofer is set to “None”.
See
Sound Effect
You can set sound effects.
1
Touch [Sound Effect].
Sound Effect screen appears.
See the following section for each setting.
• Set space enhancer
• Set highway sound
• Set up elevation
• Set up realizer or supreme
Space Enhancer
1
Touch [Space Enhancer] in the Sound
Effect screen.
Space Enhancer screen appears.
2
Touch [Small], [Large], or [OFF].
Each setting value indicates the
soundscape level.
NOTE
• This setting is not available during tuner source.