beautypg.com

Controlling general audio, P.85), P.84) – Kenwood DNX9210BT User Manual

Page 43

background image

84

84

85

Return to the Top page

Audio Setting Up

Return to the Top page

Audio Setting Up

Car type setup

You can setup the car type and speaker

network, etc.

1

Touch [Car Type] in the Audio SETUP
screen.
Car Type screen appears.

2

Select your car type from the list.

NOTE

• If your car type is selected, the Delay Time

Alignment is set automatically (for timing
adjustment of sound output for each channel) to
have the highest surround effects.

Speaker location setup

1

In the Car Type screen, touch
[Location].
Speaker Location screen appears.

2

Select the speaker locations using
[

3].

Front Speaker
Select the location from “Door”/ “On Dash”/
“Under Dash”.
Rear Speaker
Select the location from “Door”/ “Rear Deck”,
“2nd Row”/ “3rd Row” (Minivan, Passenger Van).

DSP select

You can select whether using DSP (Digital

Signal Processor) System.

1

Touch [Bypass] or [Through] of [DSP
Select] in the Audio SETUP screen.

Bypass
There is no effect by DSP.
Through
There is an effect by DSP.

NOTE

• When the mode is set to [Bypass], DSP System

cannot be adjusted.

Controlling General Audio

1

Touch [Audio Control].

2

Set each item as follows.

Fader #/Balance #
Adjust the volume balance around the
touched area.
[

2] and [3] adjust the right and left volume

balance.
[

5] and [∞] adjust the front and rear volume

balance.
Volume Offset*
Finely adjust the volume of the current source
to minimize the difference in volume between
different sources.
Subwoofer Level
Adjusts the subwoofer volume. This setting is
not available when subwoofer is set to “None”.
See

Speaker setup (P.82)

.

Bass Boost
Sets the amount of bass boost among “OFF”/
“Level1”/ “Level2”/ “Level3”.

* If you have increased the volume first, then

reduced the volume using the “Volume

Offset”, the sound generated if you

suddenly switch to another source may be

extremely loud.