Navigate, P.41), Voice memo – Kenwood DNX9210BT User Manual
Page 21: Device select (p.40), Station list screen (p.40)
40
40
41
CD, Disc, iPod, USB device, SD card
CD, Disc, iPod, USB device, SD card
Device select
You can display a Device select screen for
device selection.
1
Touch [
] in the control screen.
The Device select screen appears.
Device selection
Bluetooth: Uses the Android smartphone
connected via Bluetooth for an Aha
connection.
Wired: Uses the iPhone connected via the
KCA-iP202 (optional accessory) for an
Aha connection.
NOTE
• If you touch [
] when no device has been
connected, a popup screen that allows device
selection only appears.
• An iPhone connected via Bluetooth cannot be
used for an Aha connection.
• If the volume of Aha received by a Bluetooth
device is too low, raise it on the Bluetooth device.
Station list screen
You can perform the following functions
from this screen.
Selects the station
Touch the station name in the list.
NOTE
• You cannot select iPod as rear source when
you select Aha as main source in dual zone
function.
Voice memo
1
Touch [
] in the control screen.
Status bar
Confirms the current location.
[Start]
Starts recording the voice memo.
[Stop]
Stops recording the voice memo.
[Send]
Sends the recorded voice memo.
[Cancel]
Cancels the voice memo and returns to the
control screen.
NOTE
• This function is available from an iPhone (iOS 5
or later) connected via the KCA-iP202 (optional
accessory).
• This function is not available from an Android
device connected via Bluetooth.
Navigate
Sets the location information received from
Aha at the destination of navigation.
1
Touch [
] in the control screen.
[Save]
Saves the location information.
[Go!]
Sets the location information at the destination
and starts navigation.