Ext sw setup (p.73), P.72), P.73) – Kenwood DNX9210BT User Manual
Page 37
72
72
73
Security setup
operation
You can set up a security code to protect
your receiver system against theft.
NOTE
• When the Security Code function is activated, the
code cannot be changed and the function cannot
be released. Note the Security Code can be set as
the 4 digit number of your choice.
1
Touch [Security] in the System Menu
screen.
Security screen appears.
2
Touch [ON] of [SI].
NOTE
• If “SI” is turned on, the SI indicator on the sub
panel flashes when the vehicle ignition is off and
the panel is detached. Default is “ON”.
3
Touch [SET] of [Security Code Set].
NOTE
• If you have already completed the code
registration, [CLR] is displayed.
4
Enter a security code with four-digit
number and touch [Enter].
5
Enter the same code again and touch
[Enter].
Security code is registered.
NOTE
• If you enter a different security code, the screen
returns to step 4 (for the first code entry).
• If you have pressed
have disconnected the Receiver from battery,
enter the correct security code as that you have
entered in step 4 and touch [Enter]. You can use
your Receiver.
EXT SW setup
Set up the external switch power mode.
1
Touch [EXT SW] in the System Menu
screen.
EXT SW screen appears.
2
Set each item as follows.
SW Name
Sets the name of the external device.
Output Pattern
Sets the power signal output mode among
“Pulse”/“Level”. Default is “Pulse”.
You can set to turn output on/off each time
the button on the EXT SW screen is touched.
See
External Device Control (P.80)
Pulse Set
Sets the pulse signal output time.
Outputs 500ms when “1” is set.
Increases by 200ms with each step. Up to 100
steps can be set.
NOTE
• You can enter characters only after you have
applied the parking brake.
• “Pulse”: Generates a single power signal pulse.
• “Level”: Continues output of high power signal.
Setup memory
Audio Control, AV-IN SETUP, Camera, and
Audio SETUP settings can be memorized. The
memorized settings can be recalled at any
time. For example, even when the settings
are cleared due to replacement of the
battery, the settings can be restored.
1
Touch [SETUP Memory] in the System
Menu screen.
SETUP Memory screen appears.
2
Follow the instruction on the screen.
[Lock]/[Unlock]*
Locks or unlocks the AV-IN SETUP, and Audio
SETUP settings.
Yes
Memorizes or recalls the settings.
No
Cancels the function or memorization.
The SETUP Menu screen appears again.
* When [Lock] is selected, you cannot change
the AV-IN SETUP, and Audio SETUP settings.
Also, the locked key mark is displayed
under each setting icon in the setup menu.
Continued