Siemens EC645PB90E - Manual (Page 12)

13
Electric hobs
Before using the hob for the first time, heat it up for 5
minutes, set to full power, with no pans placed on it. At
this point it is normal to notice smoke and odours, but
these will disappear over time. Do not operate the hobs
without placing pans on top, except during this initial
heating phase.
It is recommended to start cooking on full power and,
depending on the quantity and quality of food, later switch
to an intermediate setting for the remaining cooking time.
Taking advantage of the hob's thermal inertia, you can
switch the hob off shortly before you finish cooking. This
will save energy, as you can continue cooking using the
residual heat.
Use pans with bottoms which are thick and perfectly flat.
Make sure that the size of the pan used is similar to that
of the heating element, never smaller.
Do not allow liquids to be spilt on the surface of the hob
and do not use wet pans on the hob.
If prolongued use has worn away the surface of the
electrical hot plates, sprinkle them with a few drops of oil
or other manteinance products that are widely available.
Electric hobs with
continuous energy
regulator
These hobs are operated using an energy control
regulator which you can use to select the appropriate
power level for the food you are cooking. Fig. 4.
Bearing in mind the type of cooking and the quantity of
food, using the table below as a guide, turn the control
knob to the left, selecting the setting for the dish you want
to cook. The operating indicator light will come on. To
switch off the hob, turn the control knob to the 0 setting.
The indicator light will go out.
Fig. 4.