Videoswitch Vi-M series - Manual (Page 35)

Digital Recorder
1.1.1.27 Use relay2 for critical alert
Relay 2 is normal is used to indicate that a critical alert has occurred. Set this to False if you
want to use the relay for another purpose, for example remote control of lights etc.
6.5 Network
Images from this DVR can be remotely viewed and menus accessed via:
• Local area network - connect to the Ethernet port.
• Broadband - connect a router to the Ethernet port.
1.1.19 IP address
If you wish to use the Ethernet port for local or Ethernet access, you need to give the DVR
an IP address.
If the DVR is on a network with other computer equipment, a compatible number should be
chosen. You may need to consult whoever is responsible for the network who can assign
you a number.
If you are connecting only to a broadband router, the default IP address should be
satisfactory. The router will also need setting. See our web site for details:
www.videoswitch.co.uk
1.1.20 Ports
1.1.1.28 Command
The DVR has a port dedicated for control. The default is 9221 (press DEFAULT). The Vi-
Viewer software that is used to view images remotely must specify this port in its setup. If a
router is used it must also be set up to suit. See our web site for details:
www.videoswitch.co.uk
1.1.1.29 Video
The DVR has a port dedicated for video. The default is 9222 (press DEFAULT). The Vi-
Viewer software that is used to view images remotely must specify this port in its setup . If a
router is used it must also be set up to suit. See our web site for details:
www.videoswitch.co.uk
1.1.21 Sub-net mask
Enter required subnet mask. Press DEFAULT for the default setting.
1.1.22 Gateway
29