Videoswitch Vi-M series - Manual (Page 33)

Digital Recorder
Specify during which hours of the weekend the alarm inputs are active
1.1.1.21 Enable alarms all day
This menu option allows some or all cameras to have their alarms enabled all day,
irrespective of the Weekday and Weekend alarm time settings.
1.1.13 Activity
Activity (movement) detection may be set for all cameras. The following parameters should
be set:
• Zone
Use DEFAULT to turn all zones on or off. Use the up, down, left
and right keys to move the cursor around turning zones on of off.
Press SEL to toggle whether sones rae being turned on or off.
• Level
Press zero to bring control to this setting and enter a number 1-9 to
specify the sensitivity (9 is most sensitive)
• Spatial
Press zero to bring control to this setting and enter a number 1-9 to
specify the spatial sensitivity Spatial sensitivity determines how
large an object has to be to be detected. A setting of 9 will be most
sensitive and will detect small objects.
1.1.1.22 Activity timers
Activity detection may be programmed to be operative only during particular hours of the
day. These hours may be different for weekdays and weekends.
1.1.1.23 Weekday activity times
Specify during which hours of each weekday activity detection is active
1.1.1.24 Weekend activity times
Specify during which hours of the weekend the alarm activity detection is active
1.1.1.25 Enable activity all day
This menu option allows some or all cameras to have their activity detection enabled all day,
irrespective of the Weekday and Weekend alarm time settings.
1.1.14 Critical alerts
1.1.1.1.16 Videloss
Specify here which cameras should be present. If any lose video, a critical alert will be
raised. Press DEFAULT to automatically set this to match the currently installed cameras.
1.1.1.1.17 Record stopped
Specify whether you want a critical alert to occur if record stops due to a disc or other fault.
1.1.1.1.18 Hard drives
Specify here which hard drives should be present. If a hard drive selected on this list fails, a
27