Controller specification, Controller mounting information, Evc/epc controller – High Country Tek epc, Electronic Pump Controller - A Multi-Function SAE J1939 Compatible Module User Manual
Page 5: With sae j1939 interface, 114mm, 2x ø5

023-00354-Rev1.6
evc/epc User Manual
5
Copyright © High Country Tek, Inc.
– 2013
evc/epc Controller
With SAE J1939 Interface
Controller Specification
48.5mm
125mm
5
8
m
m
4
3
9
10 11 12
2
1
6
5
7
8
114mm
CL
2x Ø5
Controller Mounting Information
Mount controller in an easily accessible
location.
Mount controller to a flat, cool surface.
If mounting to a hydraulic product, allow at
least a 2mm air gap underneath the unit.
Use BOTH mounting holes with correct
hardware.
DO NOT mount controller with connector
facing UP if possible.
Housing Type
HCT encapsulated block
Power Supply Voltage 9 to 32VDC
(Absolute maximum)
Current Consumption
Valve current + 50mA Quiescent
(Max)
Command Inputs
SAE J1939
2x switched inputs
(ON/Off)
2x analog inputs:
One with
(0-5V, 0-10V, 4-20mA)
One with
(0-5V, 0-10V, Pulse or Freq. - 3 to
30KHz)
Input Impedance
Voltage & Freq. inputs = 100k
4-20mA input = 100
Outputs
2x 3A proportional PWM
(Sourcing)
(
Short circuit protection and open circuit alert
)
1x 5VDC ±10%
(Regulated voltage @ 250mA)
PWM Dither Freq.
Software adjustable - 33 to 500Hz
Module Connector
DTF15-12PB, 12-way Male
Communication
Mini-B USB standard
Housing Material
Black, Polycarbonate
Encapsulation
Flameproof epoxy resin
Mounting
2x No.8
(5mm)
screws
Temperature Range
-40 to +85ºC
(Operational)
-60 to +90ºC
(Storage)
NEMA/IP Rating
NEMA 6P/IP67