AMETEK 2120 PLC Interface Module - Manual (Page 56)

52 Installation and Programming Manual
Appendix B: Function Summary
Chart B-2 Resolver-Specifi c Function Summary
Chart B-1 General Function
The following chart contains LDT Specifi c function summaries: LDT Input V1 and L1 Functions
The following chart contains resolver-specifi c function summaries: Resolver Input R1 Functions
Function Number Function Name Description
403 Relay Override
This function is used to temporarily allow the operator
to readjust machine position once it has exceeded a
programmed end limit.
590 Software Version
This function displays the software version of your
monitor.
Function Number Function Name Description
300 Scale Factor
This function is used to program the resolver’s scale
factor.
301 Turns Counting
This function defi nes the number of revolutions the
resolver must rotate before the scale factor is reached.
302 Position Offset
This function is used to synchronize displayed position
with actual machine position.
305 Display Power Up
This function is used to determine what will appear on
the display on Power Up.
306 Fault Pulse Time Consult factory if using LDT other than Gemco.
307 Resolver Reset-to-Preset
This function is used to set the Resolver’s Reset-to-
Preset value.
308 Select Wrap Around
This function is used in conjuction with 301 (Turns
Counting) and allows for the display to roll over after
it’s maximum count.
Function Number Function Name Description
300 Wire Speed
This function is used to program the wire speed of the
installed LDT.
301 Count Direction
This function is used to change the direction the Inter-
face Module counts as the LDT’s magnet travels along
the guide rail.
302 Position Offset
This function is used to synchronize displayed position
with actual machine position.
306 Fault Pulse Time
This function is used to program the pulse time of the
fault signal sent by the LDT when it detects an error.
307 LDT Output Type This function is used to confi gure the L1 input board
for use with a specifi ed LDT output.
311 LDT L1 Input Reset-to-Preset
This function is used to set the LDT L1 Reset-to-Preset
value.
Chart B-3 LDT Specifi c Function Summary