Red Lion BMK7A - Manual (Page 2)

INSTALLATION
BMK7/BMK7A - Closed Base Mount
Before attaching the BMK7/BMK7A to the panel or frame, it is
recommended to wire and mount the unit to ensure good electrical
connections. The following steps outline the most common sequence for
installing a unit with an MLPS attached.
1. Install the grommets (provided in the accessory bag) in the holes
in the base mount.
2. Slide the panel gasket over the rear of the unit to the back
of the bezel.
3. Remove the common and V+ screw terminals
from the rear of the unit (save for later
use), and replace them with the
hex drive stand-offs with
round washers (supplied
with the MLPS).
4. Assemble nut fastener
and mounting screw
onto both sides of the
mounting clip. The tip
of the screw should not
project from the hole in
mounting clip.
5. Route the wires from
the grommets, through
the mounting clip, into
the rear of the base mount
and out the front.
6. Connect the wires necessary for the application to the unit.
7. Install the unit through the opening in the front of the base mount until the
bezel flange makes contact.
8. Slide the mounting clip over the rear of the unit until the mounting clip is
against the inside of the base mount. The mounting clip has latching
features which engage into mating features on the unit’s housing.
Note: It is necessary to hold the unit in place when sliding the mounting
clip into position.
9. Alternately tighten each screw to ensure uniform gasket compression.
10. Connect AC power to the terminal block of the MLPS.
Note: Make sure the AC selector switch is set to the appropriate position
before applying power to the unit.
11. Mount the MLPS and optional sensor wires needed to the stand-offs using
the screw terminal from the unit with the supplied square washers.
12. Mount the base mount enclosure to the panel or frame as application
requires. Four bolts and nuts are provided with the Base Mount Kit.
BMK70000
BMK7A000
BMK60000 OPEN BASE MOUNT KIT
BMK
PART NUMBER DESCRIPTION MODEL NO
ORDERING INFORMATION
Red Lion Controls
20 Willow Springs Circle
York PA 17406
Tel +1 (717) 767-6511
Fax +1 (717) 764-0839
Red Lion Controls AP
Unit 101, XinAn Plaza
Building 13, No.99 Tianzhou Road
ShangHai, P.R. China 200223
Tel +86 21 6113-3688
Fax +86 21 6113-3683
Red Lion Controls BV
Printerweg 10
NL - 3821 AD Amersfoort
Tel +31 (0) 334 723 225
Fax +31 (0) 334 893 793
CLOSED BASE MOUNT KIT (DT8, CUB4)
CLOSED BASE MOUNT KIT (CUB5)
For More information on Pricing, Enclosures & Panel Mount Kits refer to
the RLC Catalog or contact your local RLC Distributor.