Wiring using the screw terminals, Figure 23, Screw terminal block – Vaisala WMT52 User Manual
Page 46

User’s Guide ______________________________________________________________________
44 ___________________________________________________________________M210925EN-B
Wiring Using the Screw Terminals
1.
Loosen the three screws at the bottom of the WMT52.
2.
Pull out the bottom part of the sensor.
3.
Insert the power supply wires and signal wires through the cable
gland(s) in the bottom of the sensor. Cable glands are included in
the optional Bushing and Grounding Kit (order code 222109).
4.
Connect the wires according to
.
5.
Replace the bottom part and tighten the three screws. Do not
overtighten.
0803-035
Figure 23
Screw Terminal Block
The following numbers refer to
:
1
=
Screw terminals