Vaisala DMT132 - Manual (Page 40)

USER'S GUIDE____________________________________________________________________
38 __________________________________________________________________ M211289EN-A
Show Software Information
SYSTEM
Example:
>system
Device Name : DMT132 Dewpoint transmitter
Copyright : Copyright (c) Vaisala Oyj 2011. All
rights reserved.
SW Name : DMT132
SW model : VAISALA
SW version : 1.0.0.1214
>
Configuring Analog Output
Set Analog Output Quantity and Scaling
Use the ASEL command to show or set the output quantity and the
scaling of the analog output.
ASEL [quantity] [lowlimit highlimit]
where
quantity = Quantity that is output on the analog channel:
TDF or TFDA.
lowlimit = The low limit of the output scaling in celsius.
Must be lower than high limit.
highlimit = The high limit of the output scaling in celsius.
Must be higher than low limit.
Example (show current settings):
>asel
Quantity : TDF
Level Lo : -20
Level Hi : 40
>
Example (change output quantity to TDFA):
>asel tdfa
Quantity : TDFA
Saving settings...done
Level Lo : -20
Level Hi : 40
>