Caution – Vaisala DMT132 User Manual
Page 23
Chapter 3 _______________________________________________________________ Installation
VAISALA _______________________________________________________________________ 21
1101-063
Figure 11
Tightening by Hand
4.
Use the supplied plastic 30 mm wrench to tighten the connection.
Sufficient tightness is achieved by turning 20 degrees after the
point achieved by hand.
CAUTION
Only tighten the transmitter from the 30 mm nut. Do NOT apply force to
other points in the transmitter body.
1101-064
Figure 12
Tightening with the Plastic Wrench
See also other documents in the category Vaisala Tools:
- DM500 (138 pages)
- DM70 (93 pages)
- DMT143 (76 pages)
- DMT152 (70 pages)
- DMT242 (4 pages)
- DMT340 (191 pages)
- DMT345 (185 pages)
- DPT145 (63 pages)
- DPT146 (71 pages)
- PTU300 (217 pages)
- PTB330TS (89 pages)
- PTB220 (10 pages)
- PTB220 (113 pages)
- PTB330 (144 pages)
- PTU200 (64 pages)
- PTU200MIK1 (18 pages)
- SPH10 (2 pages)
- SPH20 (2 pages)
- PTB110 (4 pages)
- PTB200 (30 pages)
- PTB210 (analog) (27 pages)
- PTB210 (serial) (32 pages)
- GM70 (68 pages)
- GMD20 (4 pages)
- GMK220 (18 pages)
- GML20 (2 pages)
- GML20T (2 pages)
- GMM20W (5 pages)
- GMM220 (6 pages)
- GMP231 (2 pages)
- GMP231 (90 pages)
- GMP343 (94 pages)
- GMR20 (2 pages)
- GMT220 (42 pages)
- GMW90 (101 pages)
- XMW90 (4 pages)
- MM70 (67 pages)
- MM70 (71 pages)
- MMT162 (66 pages)
- MMT310 (81 pages)
- MMT330 (171 pages)
- MMT330 (181 pages)