Vaisala HMT310 - Manual (Page 40)

USER'S GUIDE____________________________________________________________________
40 __________________________________________________________________ M210619EN-D
INTV Set Continuous Output Interval for
RUN-Mode
Syntax: INTV xxx yyy
Where
xxx = Output interval (0 ... 255)
yyy = Unit (s, min or h)
Example:
>intv 1
Output interval: 1 S
>intv 1 min
Output interval: 1 MIN
>intv 1 h
Output interval: 1 H
SEND Output Reading Once
Syntax in STOP-mode: SEND
Syntax in POLL-mode: SEND aa
Where
aa = Address of the transmitter when more than one transmitter is
connected to a serial bus (0 ... 99)
SMODE Set Serial Interface Mode
Syntax: SMODE x
Where
x = STOP/RUN/POLL
STOP-mode: Transmitter in standby for serial
commands
RUN-mode: Transmitter outputs data continuously
POLL-mode: Transmitter only responds to
addressed command