Vaisala HMT130 - Manual (Page 33)

Chapter 4 ________________________________________________________ Serial Line Operation
VAISALA ________________________________________________________________________ 31
Device Information and Status
Show Device Information
The ? command outputs a listing of device information.
?
Example:
>?
Device Name : HMT130
SW Name : HMT120/130
SW model : HMT130
SW version : 0.9.3.389
Serial number : "F2220101"
Address : 0
Unit : METRIC
Ch1 Status : ON
Ch2 Status : ON
Probe name : "HMP110"
Probe SW : "1.01.1"
Probe SW date : ""
Probe SN : "F0740011"
>
Set/Show Available Quantities
The CALCS command shows the abbreviations of the quantities
measured by HMT130. The command can also be used to select the
desired quantities for measurement. Only after the quantities have been
set with the CALCS command, can these quantities be selected for
different outputs (see commands DSEL, ASEL, and FORM). The
quantities in DSEL, ASEL, RSEL, and FORM must match with
CALCS.
CALCS [q1 q2]
Where
q1, q2 = Any two of the allowed quantity parameters, i.e. RH, T,
TD, TDF, A, X, H, TW, PWS, PW
Examples:
>calcs
RH Td
>
calcs td t
>