Sandvik Coromant Silent tools - application guide - Manual (Page 20)

18
Nya bilder från Borgs!
2. Milling
Programming guidelines
A general rule for face milling is to keep the milling cutter
constantly in cut, instead of running several length way passes.
This minimizes the number of entries and exits and keeps the
inserts from disadvantageous loads that could lead to vibration.
Roll into cut Keep the cutter constantly engaged
Roll into cut
Roll into the cut clockwise to get thin chips, approaching zero at the
exit. This approach will avoid vibration tendencies that can originate
from a thick-chip-at-exit approach.