beautypg.com

Installing inverter positive bus bars, Assembly – Outback Power Systems GS Load Center Installation Manual User Manual

Page 17

background image

Assembly

900-0123-01-00 Rev B

15

Installing Inverter Positive Bus Bars

Figure 16

Inverter Bus Bars

3.

Mount bus bar

A

and the top bar to the top

terminal of the disconnect on the left. Tighten
to the value shown in Table 1 on page 13.

2.

The GSLC’s hardware kit contains a top bar which attaches
to bus bar

A

. Attach these two bars together using a

5/16" flat washer, a 5/16" lock washer, and an M8 nut
(included in hardware kit). Tighten to the value shown in
Table 1 on page 13.

To assemble the Inverter Positive (+) Bus Bars:

1.

Attach bus bar

B

to the top terminal of the

disconnect on the right, using the stud and
hardware on the back of the disconnect.
Tighten the nuts to the values shown in Table
1 on page 9.

The GSLC parts kit contains two bus bars,

A

and

B

, which

attach to the tops of the DC disconnects. These bus bars make
the connections with the Radian inverter’s positive DC
terminals. Although they have similar shapes, the bus bars are
not interchangeable.

A

B

A

Top Bar

B

A