Alcatel-Lucent OMNISWITCH 6800 - Manual (Page 37)

OmniSwitch 6800 Series Chassis and Hardware Components OmniSwitch 6800-48L
OmniSwitch 6800 Series Hardware Users Guide June 2007 page 2-11
OmniSwitch 6800-48L
The OmniSwitch 6800-48L is a stackable edge/workgroup switch offering 48 10/100/Base-T ports, as well
as four combo SFP connectors for high speed connections.
The front panel of the OS6800-48L chassis contains the following major components:
• System status and slot indicator LEDs
• (44) 10/100Base-T ports
• (4) Combo 10/100/1000Base-T ports
• (4) Combo SFP connectors for 1000Base-X connections
• Console port (RJ-45)
An Optional 10 Gigabit module is also supported (see page 2-15 ).
Note. The 44 (non combo ports) 10/100Base-T ports on the OmniSwitch 6800-48L can be upgraded to
10/100/1000Base-T ports. Please contact your Alcatel-Lucent representative for more information.
Refer to the illustration below for more front panel information. For detailed LED descriptions, refer to
page 2-13 . For information on the chassis rear panel, refer to page 2-15 .
OmniSwitch 6800-48L Front Panel
OmniSwitch 6800-48L
OK
PWR
FAN
XFP1 XFP2
TMP
BPS
PRI
46
48
46
48
45 47
46 48 Console
27
28
29
30
31
32
33
34
35
36
25
26
39
40
41
42
43
44
45
46
47 LINK/ACT
48 LINK/ACT
37
38
3
4
5
6
7
8
9
10
11
12
Speed 1
Speed 2
15
16 14
17
18
19
20
21
22
23
24
13
10/100Mbps and 10/100/1000 Ports
The OS6800-48L provides 44 fixed 10/100BaseT non
combo ports (1–44) and 4 fixed 10/100/1000BaseT
combo ports (45–48). These ports are auto-sensing
and auto-MDIX and use RJ-45 connectors. Console Port
The OS6800-48L front panel provides one
RJ-45 port for console connections. Con-
sole connections are used by network
administrators for switch management.
This female RJ-45 connector provides a
DTE console connection.
Combo SFP Connectors
The OS6800-48L provides four combo SFP connectors for 1000Base-X
high-speed connections.
By default, when an SFP is installed in a combo port, it takes over the port
number of the corresponding RJ-45 Ethernet port. In other words, if an SFP
is installed in the slot labeled 45, Ethernet port 45 is no longer available and
cannot be used for 10/100/1000 traffic. This default setting is referred to as
“preferred fiber.” Refer to “Configuring Ethernet Ports” in the Network
Configuration Guide for detailed information, including steps for configur-
ing combo port settings.
Status and Slot Indicator LEDs
For detailed information on OS6800-
48L status and slot indicator LEDs,
refer to
page 2-13 .