Omniswitch 6800-48, Omniswitch 6800-48 -5, System status and slot indicator leds – Alcatel-Lucent OMNISWITCH 6800 User Manual
Page 31
OmniSwitch 6800 Series Chassis and Hardware Components
OmniSwitch 6800-48
OmniSwitch 6800 Series Hardware Users Guide
June 2007
page 2-5
OmniSwitch 6800-48
The OmniSwitch 6800-48 is a stackable edge/workgroup switch offering 48 10/100/1000Base-T ports, as
well as four combo SFP connectors for high speed connections.
The front panel of the OS6800-48 chassis contains the following major components:
•
System status and slot indicator LEDs
•
(48) 10/100/1000Base-T ports
•
(4) Combo SFP connectors for 1000Base-X connections
•
Console port (RJ-45)
An Optional 10 Gigabit module is also supported (see
Refer to the illustration below for more front panel information. For detailed LED descriptions, refer to
. For information on the chassis rear panel, refer to
.
OmniSwitch 6800-48 Front Panel
OmniSwitch 6800-48
OK
PWR
FAN
XFP1
XFP2
TMP
BPS
PRI
46
48
45
47
45
47
46
48
Console
27
28
29
30
31
32
33
34
35
36
25
26
39
40
41
42
43
44
45
46
47 LINK/ACT
48 LINK/ACT
37
38
3
4
5
6
7
8
9
10
11
12
Speed 1
Speed 2
15
16
14
17
18
19
20
21
22
23
24
13
10/100/1000Mbps Ports
The OS6800-48 provides 44 fixed 10/100/1000BaseT
ports (1–44) and 4 fixed 10/100/1000BaseT combo
ports (45–48). These ports are auto-sensing and auto-
MDIX and use RJ-45 connectors.
Console Port
The OS6800-48 front panel provides one
RJ-45 port for console connections. Con-
sole connections are used by network
administrators for switch management.
This female RJ-45 connector provides a
DTE console connection.
Combo SFP Connectors
The OS6800-48 provides four combo SFP connectors for 1000Base-X high-
speed connections.
By default, when an SFP is installed in a combo port, it takes over the port
number of the corresponding RJ-45 Ethernet port. In other words, if an SFP is
installed in the slot labeled 45, Ethernet port 45 is no longer available and
cannot be used for 10/100/1000 traffic. This default setting is referred to as
“preferred fiber.” Refer to “Configuring Ethernet Ports” in the Network Con-
figuration Guide for detailed information, including steps for configuring
combo port settings.
Status and Slot Indicator LEDs
For detailed information on OS6800-48
status and slot indicator LEDs, refer to