Alcatel-Lucent OMNISWITCH 6800 User Manual
Page 114
Changing the Secondary Module to Primary
Managing OmniSwitch 6800 Series Stacks
page 3-34
OmniSwitch 6800 Series Hardware Users Guide
June 2007
If there are only two switches in the stack, the former primary switch resumes the secondary role when it
comes back up following the takeover.
Takeover Behavior In a Stack of Two
In this stack of two OmniSwitch 6800 Series switches, the slot 1
switch is the primary management module. The slot 2 switch is
the secondary.
A takeover is initiated by the user; the primary management
module is automatically reloaded. Any data flow on the primary
switch’s Ethernet ports is interrupted.
The secondary switch takes over the primary role. Ethernet traffic
on slot 2 remains unaffected. Meanwhile the stack has no interim
secondary management module as the switch reboots.
1
2
3
-> takeover
Primary - Slot 1
Secondary - Slot 2
When the former primary switch comes back up, it assumes the
secondary management role within the stack.
4
Booting...
Primary - Slot 2
Secondary - Slot 1
Primary - Slot 2