GReddy TURBO KITS: Acura RSX Type-S 2002-03 / T517Z - Manual (Page 21)

3-16 Starting the Engine
(1) Refill the engine oil to factory spec.
(2) Check all the hoses and wires connection, then reconnect the negative side of
the battery.
(3) Turn the ignition to “ON” position 2-3 times to get fuel pressure. Then, check the
injectors and the fuel rail for any fuel leaks.
* Repair any fuel leaks before starting the engine. Starting the engine with a
fuel leak can cause fire in the engine compartment and can be very
dangerous.
(4) Remove the ECM fuse and crank the engine to get oil pressure to the turbo.
(Until the oil light on the dash turns off) Check for any oil leaks, then reinstall the
fuse and start the engine.
(5) While idling, check for any oil, coolant, or air leeks.
(6) After inspection, reinstall the under cover and other stock parts that was
removed.
(7) On the initial run, be sure to have a boost gauge to check the turbo-actuator
setting. This turbo kit is preset to boost between 0.6kg/cm 2 to 0.6kg/cm 2 .
It is very important that you monitor the boost pressure, and make sure not to
over boost. Over boosting can cause engine damage.
This completes the Turbo Kit installation.
Important!
• It is very important that you monitor the boost pressure, and make sure
not to over boost. Over boosting can cause engine damage.
• GReddy Performance Products, Inc. is not responsible for any engine
damage caused by over boosting (increased boost), modification to the
kit, and/or misuse of the product. NO WARRANTY is offered.
• Due to lack of control over proper installation and use of this product,
NO WARRANTY is offered for this kit.