DAVIS SmartCard Users Guide (8105, 8108, 8112) - Manual (Page 8)

6
M o u n t i n g t h e O n - B o a r d R e a d e r
Thread the DriveRight connector cable down
one of the large inner grooves. Thread the
GPS module or Digital Input connector cable
down the other large inner groove. Thread the
Starter Interrupter Cable down one of the
thinner outer grooves depending on your
wiring orientation.
Do this before mounting. Once your mount-
ing option is in place, it may be hard to secure
the wires into the grooves.
Mounting with Velcro Tabs
The hardware kit contains six Velcro tabs for
attaching the On-Board Reader to the dash-
board or some other accessible area in the
vehicle. To attach the Velcro tabs:
1. Make sure the back of the On-Board
Reader and the surface you are adhering
the On-Board Reader to are clean and
wiped of any dust or debris.
2. Remove the backing on one side of the
Velcro tabs.
3. Apply the Velcro tabs to the back of the
On-Board Reader. Davis recommends that
four of the Velcro tabs be placed between
the wire grooves next to each other.
4. Remove the backing from the other side of
the Velcro tabs and place on the dashboard
or designated area.
Mounting with Double-Sided
Foam Tape
The hardware kit contains eight double-sided
foam tape tabs for attaching the On-Board
Reader to the dashboard or some other acces-
sible area in the vehicle. To attach the foam
tape:
1. Make sure the back of the On-Board Reader and the surface you are
adhering the On-Board Reader to are clean and wiped of any dust or debris.
2. Remove the backing on one side of the double-sided foam tape tabs.
3. Apply the tabs to the back of the On-Board Reader.
4. Remove the backing from the other side of the foam tabs and place on the
dashboard or designated area.
On-Board Reader Wiring Options
Velcro
®
or
Double-Sided
Foam Tape
Velcro or Double-Sided Tape Options