DAVIS SmartCard Users Guide (8105, 8108, 8112) - Manual (Page 10)

8
M o u n t i n g t h e O n - B o a r d R e a d e r
To install the optional
mounting plate:
1. Place the mounting
plate, with the pre-
drilled countersink
holes facing outward,
on the back of the
On-Board Reader.
2. Line up the holes with
countersinks with the
pre-drilled holes on
the On-Board Reader
located on the outside
of the wire grooves.
3. Secure the mounting
plate on the On-Board
Reader using the #6
by 1/2'' self-tapping
screws.
4. Secure the On-Board Reader to the dashboard or other surface using the
outer holes on the mounting plate.
2.25"
(57 mm)
11/64" (4.4 mm)
Hole with countersink
Template to scale
#6 x 1/2" Self-Tapping Screws
Holes for mounting
plate screws
(screws not supplied)