DAVIS SmartCard Users Guide (8105, 8108, 8112) - Manual (Page 11)

9
U s i n g t h e O n - B o a r d R e a d e r
Using the On-Board Reader
Logging In
To log in to the On-Board Reader, simply
insert the supplied SmartCard into the On-
Board Reader before starting up the vehicle.
For ease of use, you can log in with the
SmartCard in one of two ways, using Swipe
Mode or Leave-in Mode.
To log in using Swipe Mode, simply insert
the SmartCard, wait for the green indicator
light and remove the SmartCard within 5
seconds.
To log in using Leave-in Mode, insert the SmartCard in the On-Board Reader
and leave it there until the end of a trip.
The Driver ID is automatically relayed to the DriveRight device for authenti-
cation. The driver no longer needs to enter the Driver Code into the device.
If the Driver ID is accepted, one beep sounds followed by the green indicator
light. If the optional Starter Interrupter Kit is installed, the vehicle is enabled
to start. When login is successful, the green LED stays on as long as the vehi-
cle is in motion. Otherwise, it goes off after 10 minutes to save power.
If the Driver ID is not authorized, two beeps sound and the red indicator lights.
If the optional Starter Interrupter Kit is installed, the vehicle is prohibited from
starting. A Driver ID is not authorized if the Driver ID on the SmartCard does
not match up to the driver list kept on the DriveRight device. If the SmartCard
also contains a vehicle list, both the vehicle and Driver ID on the SmartCard
must match that of the DriveRight device.
If the SmartCard is inserted incorrectly or if there is an error reading the
SmartCard, the yellow indicator lights. Reinsert the card and try again or see
your administrator if you are having difficulties.
Note: When the vehicle is moving, all SmartCard functions (logging in and out, downloading,
uploading, etc.) are disabled. If attempted, the red indicator lights and two short beeps
sound, indicating user error.
Logging Out
Logging out of the SmartCard On-Board Reader happens in one of two ways:
Auto Logout and Manual Logout.
If you are using the card in Swipe Mode to log in, the On-Board Reader will
initiate Auto Logout at the end of a trip. Auto Logout occurs automatically
after a preset amount of time has elapsed. The On-Board Reader automatically