DAVIS SmartCard Users Guide (8105, 8108, 8112) - Manual (Page 14)

12
I n s t a l l i n g t h e S t a r t e r I n t e r r u p t e r K i t
Components
The Starter Interrupter Kit comes with the components and hardware shown in
the following illustration. Make sure you have all the necessary components
before proceeding:
Installation and Wiring
The Starter Interrupter Kit is installed between the On-Board Reader and the
vehicle’s starter switch wire. Use the diagram on the next page to connect the
Starter Interrupter Kit to the On-Board Reader and the vehicle’s ignition sys-
tem.
Relay with Harness
Butt Splices
(16-22AWG)
In-Line Splices
#8 x 3/4"
Sheet Metal
Screw
#8 Flat
Washer