DAVIS Weather Monitor II EZ-Mount - Manual (Page 2)

Page 2 EZ-Mount Weather Station
T OOLS AND M ATERIALS N EEDED
In addition to the components listed above, you may need some of the follow-
ing tools and materials.
✦ Flat-Bladed Screwdriver
✦ Phillips Screwdriver
✦ Adjustable Wrench
✦ Wire Cutter or Scissors
✦ Electrical Tape
✦ Cable Clips or Weather Resistant Cable Ties
With screw holes and screws or other means for mounting
✦ Hammer
I NSTALLATION S TEPS
This manual takes you through the step-by-step process of installing your
weather station. These steps are indicated below, along with their page num-
bers for easy reference:
✦ Assemble and test the station, page 3
✦ Detach the extension tube, page 3
✦ Attach the anemometer, page 3
✦ Attach the wind cups, page 3
✦ Snip the cable tie in the rain collector, page 4
✦ Apply power to the console, page 4
✦ Plug cable from sensor array into console, page 5
✦ Check that the console and sensors are working properly, page 5
✦ Re-attach rain collector cone and unplug sensor array cable from
console, page 5
✦ Install the station, page 5
✦ Choose locations for the sensor array and console, page 5
✦ Mount and secure the sensor array, page 5
✦ Run sensor array cable to console, page 7
✦ Mount the console, page 7
If, once installed, you encounter any problems with the station, please refer to
the troubleshooting guide on page 8 or call our technical support line for assis-
tance.