beautypg.com

Mounting on a post or flat surface – DAVIS Universal Shelter (6618) User Manual

Page 6

background image

5

1. While holding the shelter against the pole, place a U-bolt around the pole and

through the two holes at the top of the shelter.

2. Place a backing plate, a washer, and a hex nut on each of the bolt ends.
3. Tighten the nuts using an adjustable wrench or 7/16'' wrench.
4. Place the second U-bolt around the pole and through the two holes at the

bottom of the shelter. Put a backing plate, a washer, and a hex nut on each bolt
end, and tighten the hex nuts.

Mounting on a Post or Flat Surface

Attach the shelter to the mounting surface in the desired location using the large
screws and backing plates as shown below. Use a pencil or a center-punch to mark
the location of the pilot hole.

1. With a 3/16'' (5 mm) drill bit, drill two holes approximately 2"(50 mm) apart.

Use a carpenter’s level to ensure the holes will be level.

2. Drill two more holes 7-1/32'' below the upper holes.
3. Insert the 1/4'' x 1-1/2'' lag screws through the washers, backing plates, and

through the holes at the top of the shelter into the post.

4. Using an adjustable wrench or 7/16'' wrench, tighten the lag screws.
5. Repeat steps 3 and 4 for the bottom of the shelter.