DAVIS Vantage Pro/Pro Plus: Daytime Fan Asp. Radiation Shield Kit - Manual (Page 2)

2
Tools Needed
You may need some or all of the following tools and other items to complete the
upgrade:
• A medium Phillips-Head screwdriver
• A medium slot-tip screwdriver
•
Cabled ISS Only:
Wire cutters
• Other tools as required to remove and re-mount the ISS
•
Wireless ISS Only:
CR-123A 3-volt lithium battery (optional)
Note: If you are upgrading an ISS that has been in service for a year or more, you should consider
changing the ISS battery during the upgrade.
Installation Overview
Installing the Daytime Fan Kit is not very complicated and should take only 30 to 60
minutes to complete.
These are the steps to install the Daytime Fan components:
1.
Put the console into Setup Mode.
2.
Take the ISS down from its installed position.
3.
Disassemble the standard radiation shield.
4.
Remove the solar panel if you have a Wireless ISS.
5.
Assemble the lower section of the fan-aspirated shield.
6.
Install the fan unit.
7.
Assemble the upper section of the fan-aspirated shield.
8.
Re-Install the ISS.
9.
Take the console out of Setup Mode.
#8 Split-Lock Washers (6)
#8 Flat Washers (6)
#4 x 3/8" Screw
#4 Flat Washer
Cable Clamp
#8-32 x 3-1/4"
Screws (3) Power Cable
Assembly
#8-32 x 1/2" Screws (3)
Threaded Spacers (3)
4" Cable Tie
12" Cable Ties (2)
Cable Tie Mount
Figure 2. Daytime Fan Kit Hardware