DAVIS Terminal Box for sensors/interface module, communication lines: GroWeather - Manual (Page 3)

Mounting the Terminal Box Page 3
M OUNTING THE T ERMINAL B OX
You may mount the Terminal Box against a wall or other vertical surface or you
may simply lay it down on a horizontal surface. The preferred mounting
method is to mount it on a vertical surface in a protected location with the rub-
ber grommet facing down.
Note: You may install the wires through the grommet and into the terminal blocks before or after mounting
the Terminal Box.
1. Hold the Terminal Box against the mounting surface and mark the location of the two
screw holes.
Use a pencil or a center punch to mark the location of the screw holes.
2. Drill pilot holes in the marked locations using a drill with a #29 (.136”, 3.5 mm) drill
bit.
3. Secure the Terminal Box to the mounting surface using the #8 x
Ω
” (19 mm) screws
as shown below.
M OUNTING THE T ERMINAL B OX