DAVIS Rain Collector Shelf: GroWeather, EnviroMonitor, Weather Monitor & Wizard - Manual (Page 6)

Page 6 Rain Collector Shelf Manual
A TTACHING THE R AIN C OLLECTOR II TO THE S HELF
1. Remove the Rain Collector II’s cone from the base.
Consult your Rain Collector II manual for instructions.
2. If necessary, detach the Rain Collector II from its current mounting surface by remov-
ing the screws from the base.
Consult your Rain Collector II manual for instructions.
3. Position the Rain Collector II base on the shelf so the holes on the base line up with
the holes in the shelf.
The four large holes in the shelf are for water runoff.
4. Insert one #8-32 x 3/4" screw into each of the holes.
5. Attach the Rain Collector II base to the shelf using a #8 flat washer, a #8 split lock
washer, and a #8-32 hex nut on each of the screws.
Tighten until the base is securely fastened to the shelf.
A TTACHING THE R AIN C OLLECTOR II TO THE S HELF
6. Replace the Rain Collector II’s cone.
Consult your Rain Collector II manual for instructions.