DAVIS Rain Collector Shelf: GroWeather, EnviroMonitor, Weather Monitor & Wizard - Manual (Page 4)

Page 4 Rain Collector Shelf Manual
M OUNTING THE S HELF ONTO THE S ENSOR M OUNTING A RM
1. Position the shelf so the holes in the sides line up with the holes in the Sensor Mount-
ing Arm’s mounting bracket.
2. Place a #8 flat washer over the end of each #8-32 x 3/4" screw.
3. Slide one #8-32 x 3/4" screw (with washer) into each of the four holes on the side of
the shelf and through the holes in the Sensor Mounting Arm’s mounting bracket.
4. Attach the shelf to the mounting bracket using one #8 flat washer, one #8 split lock
washer, and one #8-32 hex nut on each of the screws.
Tighten until the shelf is securely attached to the mounting bracket.
M OUNTING THE S HELF ONTO THE S ENSOR M OUNTING A RM