DAVIS Interface Cable Adapter Module - Manual (Page 6)

Page 6 Interface Cable Adapter Module
If you wish to connect to the terminal block connector, you will need
to determine the wire assignments for the terminal block. To do this,
hold the standard cable, latch lever upward, facing the terminal
block, as shown in the illustration below. The wires in the cable are
now in the same sequence as the terminals. For future reference,
write the wire colors into the spaces provided below if they do not
match the colors marked on the circuit board.
D ETERMINING W IRE A SSIGNMENTS
To connect standard cable, first strip 4” (10 cm) of cable jacket (the
grey outer covering) and strip 5/16” (8 mm) of insulation (the
colored covering) from each wire. Run the wires through the ferrite
bead. You may then attach a new RJ45 connector and plug into the
modular connector C2. Or you may connect to the terminal block
connector C2. To place wires into a terminal, use a small screwdriver
to push down on the lever next to the terminal, insert the exposed
wire into the opening created, and release the lever. When you
release the lever, the wire(s) will be held in place.