Actron KAL9620A - Manual (Page 23)

9620 Professional OBD II Scan Tool 23
Enter Code: P0100 |
Use Arrow Key ^
To Change Or Press
ENTER To Accept
P0A08
DC/DC Converter ]
Status Circuit [
OBDII Function List |
13)Review Data ]
14)PrintData
`15)Code Lookup
Enter Code: P0A08 |
Use Arrow Key ^
To Change Or Press
ENTER To Accept
P1100
Manufacture Contrl ]
[
Fuel Air Metering
3.2 Code Lookup
Code Lookup is used to look up definitions of Diagnostic Trouble Codes (DTCs) stored
in the scan tool. The scan tool does not require power from the vehicle to perform this
function. Internal battery power can be used.
To look up DTC definitions, select Code Lookup
from the OBDII Function List and press ENTER.
NOTE: When entering codes, only one character can be changed at a time.
To enter a code:
• Use the LEFT/RIGHT arrow keys to move
the ^ symbol under the character that
needs to be changed. The cursor moves
to the right and wraps around to the
beginning when the end is reached.
• Use the UP/DOWN arrow keys to change
the selected character.
• Press the ENTER key to display the
definition.
After entering the code and pressing ENTER,
the code and definition display.
If the DTC is manufacturer specific or does not
exist for the vehicle, some information can be
determined based on the range of the DTC (see
page 24)
In the definition screen, pressing the ([) or (]) arrow key increments/decrements the
code and its definition. Undefined codes are skipped.
Press the BACK key to return to the Enter Code screen. Press the BACK key again to
return to the OBDII Function List.
NOTE: Refer to an appropriate vehicle service manual for manufacturer specific codes.