Actron KAL9620A - Manual (Page 17)

9620 Professional OBD II Scan Tool 17
Applicable tests are displayed . Select a test and press ENTER.
Requested test results are displayed on Scan Tool
On Non-CAN vehicles Scan Tool displays:
On the 1st line is where the test data (test ID) came from.
On the 2nd line is the test heading.
On the 3rd and 4th line is the test measurement (MEAS), specification value (SPEC) and
status (STS). Measurements and Specification values are hexadecimal numbers (i.e.,
$1A, $FE, $11.)
On CAN vehicles Scan Tool displays:
On the 1st line is where the monitor test data came from. ($00) represents the
source module id from where the data originated.
On the 2nd line is the test performed. The test performed can be $## if test is not
defined. Refer to vehicle service manual for details.
On the 3rd line are the measured value and units in (Volts, Amps, Seconds, etc.) and
status of monitor test data.
On the 4th line, the minimum and maximum limits are shown for the monitor test data.
If additional tests are present, use the up and down arrow to view test results.
Refer to appropriate vehicle service manual for test IDs and definitions.
Press BACK key to return to the Diag Mon Test menu or press ENTER key to return
to OBDII Function List.
2.3.9 On-Board Systems
This test allows scan tool to control operation of vehicle components, tests or systems.
Some manufacturers do not allow tools to control vehicle systems. A vehicle not supporting
an on-board system is identified by a message displayed when selected.
NOTE: Refer to vehicle service manual for on-board systems instructions.
Select On-Board Systems from OBDII Function
List and press ENTER. A list of on-board systems
and components available for testing display on
screen.
Select a test and press ENTER to activate test.
The manufacturer is responsible for determining criteria to automatically stop test. Refer
to appropriate vehicle service manual.
2.3.10 Record Data
Record Data function records PIDs while vehicle is parked or being driven. This function
is mainly used for diagnosing intermittent driveability problems that cannot be isolated
by any other method. The scan tool can maintain only one recording at a time. Be sure to
thoroughly review old recording before erasing.
Select Record Data from OBDII Function List
and press ENTER. Follow all instructions on
display.
OBDII Function List |
7)O2 Monitor Test ]
8)Non-Contin Test [
`9)On-Board Systems
OBDII Function List |
`10)Record Data ]
11) Vehicle Info [
12)Modules Present
Diag Mon Data Avail
$01
$05 [
$10 ~
NON-CAN VEHICLES CAN VEHICLES
Diag Mon Data Avail
O2 Sensor B1S1
Catalyst B1 [
EVAP (0.090) ~