Telenav for Nextel Supported Devices: v3.6 for Motorola i710, i730, i733, i736, i830 - Manual (Page 29)

© TELENAV 2003-5 PAGE 29 OF 33
seconds. When TeleNav is using packet data service to contact the TeleNav servers, it will present a message
like: a) Reading GPS…, b) Waiting …, c) Sending …, d) Receiving…, e) Logging in…, f) Personalizing …, g)
Loading icons…, h) Loading audio, and i) Storing audio. You will also notice a small network activity indicator in the
upper right corner of the map display after you press a key to pan or zoom the map.
Taking an Incoming Call
When your phone receives an incoming call ring, it will ring, and display a screen that allows you to take or ignore
the call. If you take the call, TeleNav will be operating but “suspended”. After the call, press the RED End/Home
Key to end the call, and then press the MENU key. Highlight Java Apps, and press the OK key. The presented
menu will include a “suspended apps” folder. Highlight this folder, and press the OK key. Then, highlight TeleNav
3, and press the OK key again to “awaken” TeleNav. If TeleNav has been suspended for a while from GPS
Navigation, it may ask you to confirm that you are continuing to the same destination.
You can also press the RED End/Home Key while TeleNav is running to force it to suspend. Use the steps
described immediately above to awaken TeleNav.
9. Personalizing
We suggest placing TeleNav as the right softkey option on the main Nextel screen. This allows you to a) more
rapidly start TeleNav when you need it, and b) rapidly resume TeleNav after you have made a voice call to dictate
an address from within TeleNav. To perform this personalization, follow these steps –
1. Press the Menu key on your phone
2. Using the 4-way navigation key, highlight Settings, and then press the OK key.
3. From within the Settings menu, highlight Personalize, and again press the OK key.
4. Scroll down until Right Sftkey is highlighted, and press the OK key. 5
5. Scroll up until TeleNav is highlighted, and press the OK key again.
6. Then, press Back until you have returned to the Nextel home screen.
NOTE: The default use for the right softkey is “Messages”, should you wish to change it back.
10. Error Conditions
Unable to reach server
If you see an activity screen for 45 seconds followed by a message that says, “Unable to reach server”, and it is
your first attempt at using TeleNav, you should contact Nextel customer care to resolve this issue. Most likely, your
Total Connect packet data service is not provisioned correctly.
If you drive into an area where there is intermittent or no ability to connect to the Nextel wireless network, or there is
a problem within the wire line network between Nextel wireless gateways and the TeleNav servers, and this
problem has persisted for 30 seconds or more, you will get a message stating, “Unable to reach server”. The
TeleNav application on your phone will attempt to reconnect within 7 seconds.
5 Another good choice is the UP arrow key that normally is used to activate the basic GPS feature. However, this key does not have a visible
label associated with it.