Chapter 7: setting up cycleops joule 2.0 – PowerTap Joule 2.0 User Manual
Page 53
Joule 2.0 User Guide page 53
Chapter 7: Setting Up CycleOps Joule 2.0
Manual Calibration for CycleOps PowerBeam Pro Trainer
If you use a power meter such as the PowerTap, you can perform a manual calibration to more
accurately calibrate your CycleOps PowerBeam Pro trainer. Note: the power meter must be paired
to Joule 2.0 prior to performing the manual calibration.
1. Before entering the calibration routine,
warm up the PowerBeam Pro and tires by
riding the system for fi ve minutes.
2. Press and release the [MODE] button
until Main mode is displayed.
3. Press [JOYSTICK] in and release to
select Sensors.
4. Press [JOYSTICK] up/down to highlight
RU Sensor. Press [JOYSTICK] in and
release to select RU Sensor.
5. Press [JOYSTICK] up/down to highlight
the active RU Sensor. Note: the active
RU Sensor is indicated by a hash mark next to the name in the RU Sensor list. Press [JOYSTICK] in and release to
select the active RU Sensor.
6. Press [JOYSTICK] up/down to highlight Calibration. Press [JOYSTICK] up/down to select Calibration.
7. Press [JOYSTICK] up/down to highlight Manual Calibration. Press [JOYSTICK] in and release to select Manual
Calibration.
8. Joule 2.0 will show the measured power using the current rolling resistance calibration.
9. Pedal at a constant speed to stabilize the resistance. Target 20 mph and press [JOYSTICK] up/down to change
the calibration until the displayed power matches the measured power.
10. When the two values match, press [JOYSTICK ].
11.The unique rolling resistance calibration is now incorporated into the factory calibration. This calibration will
remain in the system until another calibration is performed. Note: The Roll Down Calibration and the Manual
Calibration adjust the same calibration values. Only the last calibration values are saved.
Power Sensor: 9999 w >
>
Roll Down Calibration
Wheel Circumference >
Wheel Circumference >
The Gun Show
>
Auto Zero
>
Auto Zero
>
Pair
>
Roll Down
>
Manual
>
Reset to Defaults
>
Sensor ID
Sensor ID
The Gun Show
>
Torque Offset
>
Manual Calibration
>
Torque Offset
>
Pair New Sensor
>
Back
<
Report
Main
Calibration
Use up/down to
>
match ERU to power
sensor number.
Tu:
XXXXX
ERU Power:
>
Torque Offset
>
Manual Calibration
>
Torque Offset
>
XXX
>
Power Sensor:
XXX
>
Back
<
Report
Main
Manual Calibration