PowerTap Joule 3.0 - Manual (Page 48)

Joule 3.0 User Guide page 48
1. Press and release [MODE] until Menu mode is displayed.
2. Press [JOYSTICK] in and release to select Sensors.
3. Press [JOYSTICK] in and release to select Power Sensor.
4. Press [JOYSTICK] up/down to highlight the desired Sensor Type. For CycleOps PowerTap Plus series hubs
press [JOYSTICK] in and release to select Add PowerTap. For CycleOps Pro Series indoor cycles select Add IC
Power. For any ANT+ compatible power sensor select Add ANT+.
5. Make sure the power sensor is awake and isolated from other active sensors by 65 feet/20 meters. For Power-
Tap and IC Power sensors rotate the hub/wheel at least one revolution. For ANT+ sensors see that sensor’s user
guide for information on waking up the sensor.
6. Press the [JOYSTICK] in and release to Start Pairing. Pairing may take up to 60 seconds. Once pairing is suc-
cessful, the sensor ID will be displayed.
7. Press [JOYSTICK] up/down to highlight Name. Press [JOYSTICK] in and release to select name and change the
name of the paired power sensor.
8. For PowerTap sensors only, press [JOYSTICK] up/down to highlight the wheel circumference and press [JOY-
STICK] in and release to select wheel circumference. Press [JOYSTICK] up/down to change wheel circumference.
Press JOYSTICK in and release to save changes. For a list of common wheel circumferences see FAQ section.
Chapter 6: Sensors
Setting Up Power Sensors
Joule 3.0 is compatible with many ANT+ sensors, each having a unique code. A sensor is defined
as any ANT + compatible power meter, cadence sensor, speed sensor, heart rate strap and Cy-
cleOps resistance unit. Joule 3.0 needs to be paired to each sensor to ensure proper functionality.
Common CycleOps power sensors include the PowerTap hub, 300 Pro and 400 Pro indoor cycles.
Once set up, sensors can be managed using PowerAgent software. Note: if you purchased a
CycleOps 400 Pro or 300 Pro indoor cycle the power sensor has been paired at the factory.