BMR Suspension TAS011 - Manual (Page 7)

(CONTINUED)
36. Loosen the bolts and remove the front spring pockets from the leaf springs. (Image 15)
37. Install the BMR trailing arms into the leaf spring pockets as shown using the ½” x 5”
bolts. Thread a stainless washer under the nut then tighten to 80 ft/lbs.(Image 16)
38. Re-install the spring pockets into the body
as shown in Image 17. Leave the 3 spring
pocket bolts slightly loose.
39. Lift and insert the other end of the control
arm into the axle brackets on the highest
mounting hole and insert the supplied ½”
x 3” bolts. Thread a stainless washer and
nut onto the exposed threads. This
connection should be left loose until a
later step. NOTE: it may be necessary to
adjust the length of the control arms to
match the holes in the control arm mounts.
It may also be necessary to move the rear
end forward or back to line the mounting
holes up. If one trailing arm is adjusted,
duplicate this procedure on the other arm and verify that they are equal in length before
proceeding to the next step.
7