BMR Suspension TAS011 - Manual (Page 2)

CROSS-MEMBER INSTALLATION (Cont.)
7) Thread the supplied bolt into the body and snug the bolt allowing the frame bracket to
rotate around the axis of the bushing.
8) Repeat steps 4-7 for the passenger side. At this stage both mounts should be installed and
you can mount the cross-member. Lift the cross-member into place and insert the
supplied ½” x 4.5” bolts, stainless washers, and nuts.
9) Tighten the body mount bolts to 150 ft/lbs.
10) Center the cross-member to the driveshaft then tighten the (4) cross-member bolts.
TORQUE ARM INSTALLATION:
- The first part of this installation involves the removal of the exhaust, fuel tank, leaf springs and
rear axle. If these items have already been removed, you may proceed to step 18.
1. Lift vehicle and support with stands
under the frame, allowing the rear end to
hang.
2. Remove the rear wheels/tires.
3. If the vehicle has exhaust installed,
remove it at this time.
4. Remove the rear shocks. Using the OE
shock bolts, bolt the supplied BMR
shock plates over the factory shock holes
as shown in IMAGE 1.
5. In order to remove the rear leaf spring
bolts, it is necessary to remove the fuel
tank. Drain the tank using a drill pump
or siphon.
6. Support the tank and then remove the two mounting nuts using a 9/16” deep socket. Pull
the tank support straps down, allowing the tank to be lowered.
7. Lower the tank far enough to access the fuel lines and electrical connectors. Disconnect
and cap the fuel lines. Lower and remove the fuel tank.
(CONTINUED)
2